线路板丝印油墨

、【技术参考】

 1.产品特性：抗划伤性能好、耐酒精.亮光、遮盖力高、附着力佳、特耐酒精、耐化学品。

 2.稀释剂  ：用我司专用稀释剂  。

 3.固化剂  ：不需添加。

 4.油墨调配方法：开罐先搅拌均匀，取所需量油墨稀释到合适印刷粘度使用，没有用完的请密封好下次使用。

 5.干燥时间：常温干燥，表干时间5-10分钟，实干时间在24小时以内，48小时后达最佳性能。

【特性及使用方法】

 1.附着佳.柔软度.耐磨性佳

 2.使用时需配pu溶剂  稀释至喷涂粘度

【注意事项】

 1.先小量试印确认符合要求后再批量生产，不得与其他油墨混合使用.做套色印刷的时候，请等底层的墨干了后，再印。

 2.做好承印物的表面清除油脂及杂质工作，以促进附着效果。

 3.附着力、硬度、耐酸  性、耐酒精性、耐化学品性、抗划伤性、耐磨性等性能的检测，需要完全固化后方可检测。

   本公司长期供应线路板喷涂油墨,其良好的信誉及优质的品质长期以来受到的了广大客户的一致认可.

circuit board screen printing ink

[technical reference]

1. product features: scratch resistance【敏感词】good resistance to alcohol. light, high covering power【敏感词】good adhesion, resistance to alcohol, resistant to chemicals.

2. diluent: use our special diluent.

3. curing agent: no need to add.

4. ink deployment method: open the tank first stirring evenly, take the required amount of ink dilution to the appropriate printing viscosity use, not used up sealed, next use.

5. drying time: drying at room temperature, drying time of 5-10 minutes, solid time within 24 hours, 48 hours after the best performance.

[characteristics【敏感词】methods of use]

1. good adhesion, softness【敏感词】good abrasion resistance

2. should be diluted with pu solvent to spray viscosity when used

[notes]

1. the first small print test confirmation after the mass production, may not be mixed with other ink. when doing color printing, please wait at the bottom of the ink dry, print.

2., do a good job on the surface of the substrate to remove grease【敏感词】impurities work, in order to promote the adhesion effect.

3. adhesion, hardness, acid resistance, alcohol resistance, chemical resistance, scratch resistance, abrasion resistance【敏感词】other properties, need to be completely cured before testing.

the company long-term supply circuit board spray ink, its good reputation【敏感词】high quality has long been recognized by the vast number of customers